Le Trueblue Face à Un 5 ème Clone !

the-green · 21 mai 2012

Bonsoir tous le monde, et bah, après la sortie du PB2, la voici la team TrueBlue confrontée à un nouveau clone !! Ce dernier a d'après ce qu'on peut comprendre de l'article, possède la même coque que celle du TrueBlue, cependant la PCB du dongle est différente, le nouveau clone vient en firmware 2.50 et fonctionne parfaitement avec, une fois mis-à-jour en version 2.62, il fonctionne mais la console s'éteint toute seule chaque 30 minutes après un freeze !!!

Donc, la team TrueBlue prévoit un nouvel update du firmware dans les prochains jours afin de permettre aux utilisateurs d'identifier facilement le nouveau clone !!!

Citation:

21 - 5 - 2012

A new clone has appeared using a very similar external housing to that of True Blue. However, after removing the clone PCB from its exterior casing it becomes evident that there are a number of major differences:

Actel used is A3P125 instead of larger A3P250 used on True Blue.

Clone uses a cheap MCU and cheap dip type crystal in addition to cheaper Actel instead of full Actel integration in the original True Blue design

Clone has a tact switch which the original does not require, and switch can only be accessed by pulling PCB out of the case

Actel logic on clone is based on partial guess work of the original and will not function correctly in future updates

PCB circuit design is highly congested, with numerous visual differences evident, such as programming pads for the MCU and addiional resistors/caps

Please refer to the pictures shown below, to compare the original and clone.

A new software update will be made publicly available in the next few days which will allow users to differentiate original from clone by performing a firmware update.

Remember to deal with legit TB resellers like Lightake, Shop 01 Media, FyyGame, ModchipsAustralia, ModChipCentral, FyyGame to make sure you are getting an original product!

Source:

http://www.ps3crunch.net/

Site officiel:

http://www.truebluejb2.com/