the-green Posté(e) 9 février 2013 Share Posté(e) 9 février 2013 After the phenomenal success of our DGX product, we listened to a great deal of feedback from our loyal userbase and have implimented some changes to the design to make the DGX perform even better than before – especially for Trinity boards. DGX V1.1S change log: Added 70cm 24WG POST_OUT Wire Added a ceramic cap option (Point C29) between D and GND (same as CR3 Pro) – included an optional 10pf ceramic cap Added a selectable 5ohm and 10ohm resistor to post_out (simple solder jumpers 1 Closed: 10ohm, 2 Closed: 5ohm, 3 Closed: 0ohm Default) Added a a grounded IPEX socket (Point J1) for CPU_RST (10cm IPEX cable included) Larger solder pads and stronger vias (C D E F 5v GND) Removed JTAG pin header (Programming is not required – some users tried to program their DGX and damaged it) Optimized code for enhanced Trinity performance. DGX 1.1 would boot the worst Trinity we had in 30 seconds (v1.0 booted in 2 minutes) My preferred settings for Trinity were: D: 10cm IPEX to R4D4, C: 70cm 24AWG Wire , 10pf Cap Installed, 0ohm (Default) My preferred settings for Corona were: D: 10cm IPEX to C5R11, C: Default wire, No Cap Installed, 10ohm Remember that there may be fake DGX out there – it goes without saying that they are cheap garbage and you should stay away. Every official Xecuter product has a serial code – you should claim ownership of the code at serial.xecuter.com On sale now at most Official Resellers for only $34.95 Site officiel et source: http://team-xecuter.com/ Lien vers le commentaire Partager sur d'autres sites More sharing options...
deaphroat Posté(e) 9 février 2013 Share Posté(e) 9 février 2013 Le Dgx Se Met À Jour, Dgx V1.1S Disponible Merci pour l'information. Lien vers le commentaire Partager sur d'autres sites More sharing options...
Messages recommandés