Profils Data AP25 Pour LT+v3.0 (PATCH)


Newserator
 Share

Messages recommandés

La Team Xecuter met a disposition les Profils Data (Patch AP25) vous permettant de patcher les isos de vos propres backup xgd3 et xgd2

Le patch XGD3.Profile.ID.F87A804E.top.data.v1.bin

permet de lancer tout vos backup de jeux xgd3 actuel

Le patch XGD2.COD-BO.COD-MW2.Halo-Reach.top.data.v1.bin

Vous permet de lancer les jeux xgd2 suivant:

COD Black ops, Modern Wafare 2, Halo Reach.

Citation :

Released: 12/25/2011

================================================== =============================

After an exhaustive development process we are pleased to release these disc profile topology patches for the iXtreme LT+ v3.0 firmware.

These patches are based on millions of angle measurements spanning hundreds of hours to get the most accurate values possible.

There are currently two patches available:

1) XGD2.COD-BO.COD-MW2.Halo-Reach.top.data.v1.bin

SUITABLE FOR THE FOLLOWING GAMES ONLY:

a) Call of Duty: Black Ops

B)

Call of Duty: Modern Warfare 2

c) Halo: Reach (XGD2 ONLY, don’t use this on backups of the XGD3 beta)

These games have the exact same topology and therefore can share the same profile data. This was confirmed by doing at least 35 iterations of profile data for each game and analyzing the results. Over millions of measurements, not a single one deviated from the median by more than 1 degree, and there were no cumulative effects at all. These games are identical in the way they were mastered.

2) XGD3.Profile.ID.F87A804E.top.data.v1.bin

Suitable for all XGD3 games with this disc profile ID:

0C3DF524599094E6CB87ECC8-F87A804E

This covers all current XGD3 releases (at the time of writing) except for the Halo: Reach XGD3 beta.

Check bit.ly/ap25list and stay up to date with the latest news on the usual sites so you don’t end up patching and burning the wrong data if a new XGD3 game comes out with a different disc profile ID (there are several more already waiting in dae.bin).

Media ID shouldn’t matter since we always check our data against all foreign versions of games in DAE.bin using the targets from the v12 table and several unique per-Xbox v8 tables. Again, stay up to date with the latest news in case this situation changes.

P.S. You may be thinking that it’s better to use topology data taken from a specific title or pressing… and that may be true… but only if you do a multitude of iterations and take the average values. You would most likely

end up with extremely similar data to ours (if your drive and disc are OK), with only very small deviations where measurements were right in between two integers, and could effectively go either way.

We certainly don’t want to discourage people from doing their own measurements, but please be aware that it is very easy for some drives to screw up an angle measurement, and even small screw ups or a general bias in timing can have a great impact on LT+ responses.

P.P.S We’ve included an example of how we process our multitudes of iterations in case you think this is all a bunch of BS. It’s a massive html file so be careful if you don’t think your system or browser can handle it.

More patches will be released in the coming days or weeks as required.

Thanks go to c4eva, Seacrest, Redline99, Team Jungle & Team Xecuter.

Enjoy and Merry Christmas! We look forward to all future challenges in 2012.

Note: To inject the Topology patch file to the .iso simply download the latest Xbox Backup Creator and read the instructions – very easy to do
:)

Remember to burn your images using an Liteon iHas Burner and the BurnerMax firmware. DO NOT USE OR TRUST TRUNCATED IMAGES !

download.gif Profils Data AP25 Pour LT+v3.0

homesite.gif  Site officiel : http://team-xecuter.com/

Lien vers article original : http://x360.gx-mod.com/modules/news/article.php?storyid=3730

Lien vers le commentaire
Partager sur d'autres sites

  • Réponses 150
  • Created
  • Dernière réponse

Top Posters In This Topic

Merci pour la news :) Je vais attendre un peu juste attendre les premiers testeurs :) Voir si tout est ok !

A plus & Joyeux Noël à tous (Attention sur les routes) Et si vous avez bu prenez un taxi ou un chauffeur désigné :)

Lien vers le commentaire
Partager sur d'autres sites

Je sais tracasse ;)

mais j'avais demandé dans un autre topic si on pouvais déjà faire les backup "patché" et les utiliser sous LT 2.0 tant que le LT 3.0 n'est pas nécessaire vu que la console n'est pas sur le live et pas encore a jour avec le dash metro, et donc je viens signaler que cela fonctionne

Lien vers le commentaire
Partager sur d'autres sites

Good. Mais avec quel outil on vérifie le "disc profile id" d'un iso ou burn existant?.... XBC ne le fait pas, on n'a que le xex media id, propre à chaque jeu...

Il me parait risqué de patcher par exemple des versions PAL avec ça. Certes ça va booter mais bon le live...

Vivement abgx 1.0.6...

Lien vers le commentaire
Partager sur d'autres sites

et bien petit soucis...

en faite le jeu n'est pas patché... quelqu'un peut me dire la marche exacte à suivre car j'ai pourtant fait comme je pensait être bon...

image tools/sélectionner "inject"/AP25 Sector/charger l'iso du jeu/charger le patch "XGD3.Profile.ID.F87A804E.top.data.v1"

après cela il se patch tout seul il me semble ? car je n'ai vu aucun bouton... et bien pourtant le jeu ne passe pas sous LT 3.0...

PS : j'ai l'erreur "disque non pris en charge"

Modifié par JoN69
Lien vers le commentaire
Partager sur d'autres sites

tu peux vérifier, une fois patché tu extrais ton "ap25 sector" de ton iso et tu compares (somme de contrôle) avec "XGD3.Profile.ID.F87A804E.top.data.v1.bin" par exemple si c'est un XGD3. Si ça correspond c'est que ton iso est correctement patchée :)

cool,merci!

Lien vers le commentaire
Partager sur d'autres sites

moi j'aimerais savoir comment être sur que l'iso soit bien patchée,si quelqu'un a une technique? merci

quand tu patches avec xbox backup creator il te le dis en anglais que tu as bien injecté le fichier

sinon pour jon69 y avait pas de patch avant pour le xgd3 puisqu'il n'est pas pris en charge par abgx pour l'instant donc si un jeu xgd2 il faut pas mettre le patch xgd3

Lien vers le commentaire
Partager sur d'autres sites

quand tu patches avec xbox backup creator il te le dis en anglais que tu as bien injecté le fichier

sinon pour jon69 y avait pas de patch avant pour le xgd3 puisqu'il n'est pas pris en charge par abgx pour l'instant donc si un jeu xgd2 il faut pas mettre le patch xgd3

NFS The run est un jeu XGD3 donc il faut lui mettre le patch pour les XGD3... mais il ne fonctionne quand même pas

Lien vers le commentaire
Partager sur d'autres sites

je viens de refaire un test avec NFS (iso non patché au départ)

et voici ce que j'obtiens dans XBC :

Xbox Backup Creator v2.9 Build:0350 By Redline99

Found ODD: ATAPI iHAS124 B AL0S at [E]

Additional Info: 2011/08/11 10:09

Found ODD: OHCPEH WLEF89UNKX 1.03 at [G]

Additional Info: 11/08/09

Nero API is not available

ImgBurn 2.5.6.0 is available

ImgBurn - The Ultimate Image Burner! by LIGHTNING UK!

AP25 cannot locate dae.bin file

Injecting Sector

Xbox Format Version = Xbox360 XGD3

AP25 Sector file injected at LBA sector 16608

Mais quand je met dans la console avec LT 3.0... ce disque n'est pas pris en charge...

Lien vers le commentaire
Partager sur d'autres sites

Bonsoir tout le monde j'ai patché l'image de BF3 avec le fichier topology ID.F87A804E je vais flasher ma xbox demain par contre je vois qu'il y a des retours négatifs pour battlefield 3 j'ai lu qu'il faut ce fichier Battefield.3.LT.3.0.Topology.Data.Patch.XBOX360 si quelqu'un peut tester et confirmer merci.

Lien vers le commentaire
Partager sur d'autres sites

Créer un compte ou se connecter pour commenter

Vous devez être membre afin de pouvoir déposer un commentaire

Créer un compte

Créez un compte sur notre communauté. C’est facile !

Créer un nouveau compte

Se connecter

Vous avez déjà un compte ? Connectez-vous ici.

Connectez-vous maintenant
 Share

Annonces