g fait 1 recherche sur la commande at#cls=? qui m'intriguer et je suis tomber sur l'explication du diagnostik modem fait par xp:
http://windows.microsoft.com/windows2000/f...oncepts_208.htmsi on en croit ce qui est dit la commande at+fclass=8 ne correspond pas a une commande vocal mais 1 commande de télécopie (fax) les commande de type vocal seraient de la forme AT#cls=x !!!!
j'aprofondie les recherches et je trouve confirmation:
"To determine the fax capabilities of your modem, type AT+FCLASS=? followed by the <enter> key into the terminal window. The response should look something like this: 1,2,2.0 followed by OK. These numbers represent the Fax Classes supported by your modem. 1 is for Class1, 2 is for Class2, and 2.0 is for Class2.0. When selecting a configuration file, you should select one that matches the fax classes that your modem supports.
To determine the voice capabilities of your modem the situation is a bit more complicated. There are two basic types of voicemail commands that modems understand. Modem manufacturers implement one or the other, but never (as far as we know) both. So we first need to determine which Voice Command Set your modem understands (if any, it could be a fax only modem!). First type AT#CLS=? followed by the <enter> key. If you see the word ERROR, type AT+CLS=? followed by the <enter> key. If you still see the word ERROR, you modem is a fax only modem. If, however, you received a result similar to 1,2,2.0,8 from either of the above two commands, you have a voice modem. If the first command succeeded then you have a #V Command Set voice modem, otherwise you have a +V Command Set (ISO 101) voice modem. In order for voicemail to work properly you must have selected a config file that supports the proper voice command set. In general, USR and Rockwell based modems support the #V Command Set and Lucent modems support the +V Command Set. Make sure the configuration file you select specifies the Command Set that matches the capabilities of your modem. The best thing to do is to try and select one of the Generic Configuration files from the "Unlisted Manufacturer" group."
g aussi trouver ce site:
http://www.kengolf.com/en/voice-modem.htmce dernier décrit 1 méthode pour savoir si le modem est voice qui consiste simplement a voir si les driver pour le mode voice soint installé (ils appelle ces driver TAPI ou TSAPI)
pire le site dit qu'ils est possible d'avoir 1 modem voice mais pas les drivers permettant de faire fonctionner le mode voice!!!!
j'en viens a douter de mon modem alors je vais sur le site du constructeur et je trouve ça:
"Il dispose également de fonctions vocales incluses permettant les modes voix sur IP et répondeurs vocaux. (avec le logiciel approprié de type TAPI ou TSAPI)."
si j'en vrois la parenthese mon modem est voice par contre c a moi de trouver les driver pour utiliser ce mode (absurde)...
d'un autre coté ds le tuto à aucun moment on utilise de commande de type AT#cls=x la seul commande qui nécessite 1 modem adapter est la commande AT+FCLASS=8 or si c bien 1 commande de fax alors la majorité des modem devrai l'accepter non???