salut,
A mon avis le fichier makefile.328 va devoir être modifié, car si on l'édite , on obtient ceci
le fichier makefile.328 doit être une sorte de fichier log qui résulte de la programmation de son Atmega
# Name: Makefile
# Project: bootloadHID
# Author: Christian Starkjohann
# Creation Date: 2007-03-19
# Tabsize: 4
# Copyright: © 2007 by OBJECTIVE DEVELOPMENT Software GmbH
# License: GNU GPL v2 (see License.txt)
# This Revision: $Id: Makefile 788 2010-05-30 20:54:41Z cs $
###############################################################################
# Configure the following variables according to your AVR. The example below
# is for an ATMega8. Program the device with
# make fuse # to set the clock generator, boot section size etc.
# make flash # to load the boot loader into flash
# make lock # to protect the boot loader from overwriting
DEVICE = atmega328p
BOOTLOADER_ADDRESS = 7800
F_CPU = 16000000
FUSEH = 0xDA
FUSEL = 0xF7
FUSEE = 0x03
###############################################################################
AVRDUDE = avrdude -c stk500v1 -P //./COM6 -b 19200 -p $(DEVICE) -C "D:\Arquivos de Programas\arduino-0022\hardware\tools\avr\etc\avrdude.conf"
la dernière ligne pointe vers la config du fichier conf de avrdude
un petit lien pour comprendre dex ou trois trucs sur els fichiers makefile
http://www.wiki.jelectronique.com/winavr